Is “NACE trim” enough on the RFQ?
No. Clarify body, bolting, weld overlays and whether the full assembly must meet MR0175.
Updated 2026-11-08 · Screening reference for engineers & contractors.
Direct answer · NACE material chart
| Component | Common sour-ready direction | Notes |
|---|---|---|
| Carbon steel body | WCB/A105 with hardness control | Only within MR0175 regions & purchaser limits |
| Low-temp CS | LCB/LCC with NACE notes | Confirm impact + hardness |
| SS316 / CF8M | Often selected for mildly sour / wet | Chlorides + H2S need careful review |
| Duplex / Super Duplex | Chloride + strength | PREN & fabrication controls |
| Nickel alloys (e.g. 625/825) | Severe sour / high temp | Costly — specify only when required |
| Bolting | NACE-compliant grades | Do not overlook studs/nuts |
| Trim / stem | Hardness-limited stainless / nickel | Stellite overlays per approved procedures |
This chart does not replace the regional tables in ISO 15156. Final material selection is by corrosion engineer using gas analysis (H2S, CO2, chlorides, pH, temperature).
| Field | Why |
|---|---|
| H2S partial pressure / mol% | Sets MR0175 region |
| Temperature & chloride | Cracking / pitting risk |
| Design Class/PN & size | Construction |
| Preferred MOC family | CS / SS / Duplex / Ni |
| NACE statement | “Materials per NACE MR0175/ISO 15156” |
| Hardness / MTC scope | EN 10204 3.1 + hardness reports |
No. Clarify body, bolting, weld overlays and whether the full assembly must meet MR0175.
No. Hydrotest ≠ sour-service material compliance.
Yes when the service envelope and material family are stated on contact.html.