Pneumatic Ball Valve: Double Acting vs Single Acting Fail Modes

Technical guide · Supreme Valves India · Updated 2026-11-17

Direct answer: Double-acting (D/A) pneumatic actuators use air to open and air to close; on air failure they typically stay put. Single-acting (spring return) uses air against a spring; on air failure they go to a defined fail-open or fail-close position. Drawings that say “SINGLE ACTING” and “fail stay-put” at the same time are inconsistent — fix that before PO.

Quick comparison

Item Double acting Single acting
Air to moveBoth directionsOne direction (spring returns)
Typical fail actionStay put (unless accessories added)Fail open or fail close
Common pilot5/2 NAMUR3/2 NAMUR
Air consumptionHigher (two sides)Lower stroke air; spring sized for torque

What auto-ball tags must state

  1. Actuator: double acting or spring return
  2. Fail position on air / power loss
  3. Supply air pressure (e.g. 5–7 kg/cm²)
  4. SOV: 5/2 or 3/2, coil voltage (24 V DC / 110 V / 230 V AC), enclosure IP
  5. Limit switch: contacts for open and close (NO/NC as required), cable entry
  6. Air port thread: NPT vs BSP — match site tubing standard

PN10 body with Class 150 flanges

Many water / utility auto balls are PN10 with ASME B16.5 Class 150 drilling, or EN PN10 flanges. Say which flange standard applies. Mixing “PN10” pressure text with “150#” ends without a dual-mark note creates site fit-up risk.

Supreme Valves India packages pneumatic ball valves with actuator, SOV and limit switch as a single RFQ line when requested. Send the instrument datasheet with the mechanical tag. Related: electric fail-safe modes, RFQ.

Frequently asked questions

What does fail stay-put mean?

On air failure, a double-acting actuator without a spring cartridge remains in its last position (open or closed). That is not the same as spring-return fail-close or fail-open.

Is a 5/2 NAMUR SOV always double acting?

A 5/2 NAMUR solenoid is the usual pilot for double-acting rack-and-pinion actuators. Spring-return (single-acting) actuators more often use 3/2 pilots. Match SOV type to actuator.

24 V DC or 230 V AC coil?

Follow the plant control voltage on the instrument datasheet. Many Middle East and Indian skids standardise on 24 V DC. Do not accept 230 V AC coils unless the PLC/marshalling design requires it.

Related products & guides

Request valve RFQ →