Is wafer the same as lug?
No. Wafer clamps between flanges; lug has threaded inserts for dead-end service.
Updated 2026-11-08 · Screening reference for engineers & contractors.
Direct answer · End connection chart
| End | Typical use | Pros | Watch-outs |
|---|---|---|---|
| Flanged RF | Process & utility ≤Class 300/600 RF | Easy maintenance | Need matching flange standard |
| Flanged RTJ | Class 600+ hydrocarbon / high integrity | Metal ring seal | Ring number + groove must match |
| Buttweld (BW) | Permanent process welds | No flange leak path | Schedule must match; NDE scope |
| Socket weld (SW) | ≤2" process/utility | Compact | Gap requirements; not for severe cyclic without care |
| Screwed NPT/BSP | Instrument, air, water small bore | Cheap/fast | Thread standard (NPT vs BSP) critical |
| Wafer | Butterfly / dual-plate check | Short laying length | Needs flange alignment; not dead-end |
| Lug | Butterfly dead-end service | One-side removal | Bolt engagement / rating |
| Grooved | Fire & utility grooved pipe | Fast install | Groove standard & listed valves if fire |
| Service | Example line |
|---|---|
| Utility water | 4" Class 150 WCB gate, RF |
| Steam | 2" Class 300 WC6 globe, RF or BW Sch 40 |
| Gas pipeline | 8" Class 600 trunnion ball, RTJ, API 6D |
| HVAC CHW | DN200 PN16 DI butterfly, wafer, EPDM |
| Instrument air | ½" SS316 ball, NPT |
No. Wafer clamps between flanges; lug has threaded inserts for dead-end service.
Must match the mating fittings. Mixing sealing threads causes leaks — state the thread form on the RFQ.
Not for the flange itself; state schedule for BW ends and for Cv/velocity checks.