Electric vs Pneumatic Actuator Selection Chart

Updated 2026-11-08 · Screening reference for engineers & contractors.

Direct answer · Electric vs pneumatic

Pick pneumatic when plant instrument air exists, fast stroke and simple spring fail-safe are needed. Pick electric when air is absent, long runs make tubing costly, or precise modulating / multi-turn duty is primary. Both need ISO 5211 matching and a stated fail philosophy.

RFQ from this chart — size · class/PN · MOC · ends · actuator type · qty.

Contact / RFQ WhatsApp

Selection matrix

CriterionPneumatic (quarter-turn)Electric (Q-turn / multi-turn)
Plant utilityNeeds clean instrument airNeeds power (1ph / 3ph / DC)
Fail-safe simplicitySR spring FO/FC strong defaultNeeds battery / spring / UPS design
Stroke speedTypically faster on/offSlower; adjustable travel time
ModulatingI/P + positioner common4–20 mA / fieldbus common
Multi-turn (gate/globe)Less common (rotary via gearbox)Natural fit (rising stem)
Hazardous areaSimple mechanics; solenoid Ex ratingFull Exd / Exe enclosure selection
Cold / remote sitesAir freeze / compressor issuesOften preferred if power exists
CapEx (typical)Lower unit + accessories stackHigher actuator; less air piping
OpExAir consumption / leaksStandby power / electronics
Position feedbackLimit switches / transmitterIntegral feedback usual

Duty → preferred direction

DutyLean towardNotes
ESD / fire water / SIL on/off with IAPneumatic SRState FO/FC + solenoid de-energize action
Utility ball / butterfly on/off, IA presentPneumatic DA or SRSee sizing chart
No air, rooftop / remote skidElectricState VAC/VDC + enclosure IP / Ex
Control valve globe / cagePneumatic + positioner (or electric)Follow control valve datasheet
Large gate / globe isolationElectric multi-turn or gear + motorHandwheel override typical
High cycle modulatingEither with duty ratingAsk for cycle class / thermal rating

RFQ fields (both types)

FieldWhy it matters
Valve type + size + Class/PNTorque / thrust basis
On/off vs modulating signalSolenoid vs 4–20 mA / bus
Fail position (FO/FC/FL)SR springs or electric fail method
Air barg min / Power voltsOutput torque at site utility
Area classificationEx / non-Ex enclosure
ISO 5211 / stem driveMounting compatibility
Limit switches / positioner / MOVAccessories package
Ambient temp / enclosureIP / heaters / coatings

Manual gear operators remain valid when actuation is not justified — see handwheel / gear chart.

FAQ

Is pneumatic always better for fail-safe?

Spring-return pneumatic is the simplest fail-safe on air loss. Electric fail-safe needs spring-return electric designs, UPS/battery packs or mechanical spring modules — state the method on the RFQ.

Can electric actuators modulate?

Yes with positioners / 4–20 mA control. Pneumatic also modulates with I/P + positioner. Choose by available power (air vs electric) and loop philosophy.

What should I put on the RFQ for either type?

Valve size/class/MOC, torque or ΔP, on/off vs modulating, fail position, power (VAC/VDC or air barg), hazardous area, ISO 5211, accessories and quantity.

Related charts