Valve Handwheel Gear Operator Chart

Updated 2026-11-08 · Screening reference for engineers & contractors.

Direct answer · When gear operators are required

Specify a gear operator when rim pull exceeds site safe limits — typically gate / globe ≈ NPS 8+ (earlier at Class 300+) and butterfly ≈ DN200 / 8"+ or high ΔP. Smaller valves stay on handwheel or lever. Confirm with published stem torque at design differential pressure.

RFQ from this chart — size · class/PN · MOC · ends · HW/gear · qty.

Contact / RFQ WhatsApp

Gate / globe — operator by size (Class 150 screening)

NPS (DN)Typical Class 150Class 300 / higher ΔPNotes
½–2 (DN15–50)HandwheelHandwheelForged often rising stem HW
2½–4 (DN65–100)HandwheelHW or consider gearCheck packing friction / stem OD
6 (DN150)Handwheel (verify rim pull)Gear preferredSite HSE may force gear earlier
8 (DN200)Gear usualGearCommon EPC default threshold
10–12 (DN250–300)GearGear + optional chainwheelHigh stem thrust
14+ (DN350+)Gear / bevel / motorGear or electric actuatorSee electric vs pneumatic chart

Thresholds are industry rules of thumb, not a substitute for torque × handwheel radius ≤ allowed rim pull (often ~250–350 N depending on plant standard).

Butterfly — lever vs gear

DN (NPS)Low ΔP utilityHigher ΔP / Class 150+Accessories
DN40–100 (1½–4")LeverLever or gear—
DN125–150 (5–6")Lever / gearGearOptional LS
DN200 (8")Gear commonGearLS open/close frequent
DN250–300 (10–12")GearGearLS; ISO mount for actuator
DN350+ (14"+)Gear / actuatorGear or pneumatic/electricISO 5211 mandatory for automation

Operator type summary

OperatorUse whenRFQ keywords
HandwheelLow torque rising-stem valvesHW, OS&Y / NRS
LeverSmall butterfly / ball 90°Lever lock if needed
Worm / bevel gearRim pull exceededGear operator, ratio, handwheel dia
ChainwheelElevated valvesChainwheel + chain length
Actuator (P/E)Remote / frequent / ESDDA/SR or electric + ISO 5211

Deeper notes: gear operator selection rules · torque tools: valve torque calculator · butterfly torque estimator.

FAQ

At what size should a gate valve get a gear operator?

Common EPC practice: Class 150 gates often stay handwheel through NPS 6; specify gear from about NPS 8 upward, and earlier at Class 300+ or high stem thrust. Always verify rim pull against site HSE limits.

Do butterfly valves need gears?

Levers are typical on small low-ΔP butterflies. Gears (often with limit switches) are common from roughly DN200 / 8" upward or whenever breakaway torque exceeds safe lever effort.

Is ISO 5211 required for gears?

Gearboxes and actuators mount via ISO 5211 flanges (F05, F07, F10…). State the flange and drive square when buying valves for later actuation.

Related charts